Preventing Mold Growth After Water Damage: Tips from a Water Damage Restoration Service in Washington, MO

August 15, 2016 10:03 pm Published by Leave your thoughts

Any time you have water seeping into your home, you should be concerned about the potential for mold growth. This is true whether it’s a large amount of water from flooding or just a small amount from a leaking or broken pipe. As soon as moisture sets in, mold grows and spreads quickly and can do a great deal of harm, both to your carpets and walls and to your health.

The best way to prevent mold growth after water damage is to make sure you dry up all water as quickly as possible. The sooner you begin cleaning up the water, the better you’ll be able to put a stop to mold growth. Here are some tips from our water damage restoration service in Washington, MO to help you accomplish this:

  • Get the water out, ASAP: If there is a lot of water, you’ll want to use a wet vacuum to clean up as much as you can. This is the best tool for removing water in large quantities, and can be purchased at any home or hardware store or rented from many of those same locations. A wet/dry vacuum is always a good tool to have on hand in your home, so it’s highly recommended you get one before you actually end up needing it, just to be prepared.
  • Use fans: Fans can help to speed up the drying process. It could take several days for fans to thoroughly dry an area that has suffered water damage, but they also help to keep fresh air circulating through the area. Keep the fans going 24 hours a day for a good week. You can rent high-powered fans specifically meant for drying carpet from home improvement stores.
  • Use dehumidifiers: Dehumidifiers are also great tools for helping to remove excess moisture, which can be a significant help in preventing or limiting the growth of mildew and mold.
  • Clean your carpets: Get all of your carpets steam cleaned to make sure they have been properly sanitized and that the odors associated with water damage have been removed. Water-damaged carpet padding typically needs to be replaced entirely, but you will likely be able to save the carpet itself so long as you act quickly.
  • Sanitize everything: Anything that has been touched by water from a storm must be sanitized with soap and water. This includes walls, baseboards, hard-surface floors and anything else in your home that has made contact with the water. You can mix 1.5 cups of chlorine bleach with a gallon of water and begin scrubbing and mobbing. Make sure you wear gloves to protect your hands from the bleach!
  • Remove your furniture: Get furniture away from water as quickly as possible. This will make it easier to spot more areas where the carpet has been damaged, and also limits the amount of damage that will be done to your furniture and other possessions.

For more information about our water damage restoration service in Washington, MO, contact Premier Carpet Care & Water Damage Restoration today.

Categorised in:

This post was written by admin

Leave a Reply

Your email address will not be published. Required fields are marked *